C6 Birth Control Foaling Alarm is a kit equipped with a micro transmitter and a receiver with a GSM modem that registers up to 8 phone numbers.
How does it work?
The C6 Birth Control transmitter is installed in the mare’s vulva during the last days of pregnancy.
As with C6 EVO, the system is activated at the moment when foaling begins, notifying the breeder and all registered numbers in real time of the need for assistance.
As indicated in the user manual, during the period of non-use, we recommend leaving the system on charge for at least 24 hours every 15 days by connecting the power supply to the mains; this will allow the battery to be fully maintained.
The following checks are considered to have been carried out with the original power supply connected to the mains and to the C6 EVO, and the switch set to ON.
Check the presence of mains power and the correct insertion of the power plug; if the problem persists, send the appliance complete with accessories for repair.
The power supply unit is defective or lacks power, replace the power supply unit with an original one.
This is one of the most common defects and can be attributed to various factors.
In fact, this LED will flash after about one minute from the insertion of the SIM card, only when the whole system is ready for operation; when even one of the parameters listed below is not satisfied, the green LED remains on with a steady light:
© 2024 Foaling Alarm – Brand di Sisteck Srl – All rigths reserved – Powered by Seo Siti Marketing – VAT NUMBER / CF: IT03965290368
